PLEASE NOTE:   (1)  Order of minimum 2 spools is required for buyers of CA, WA, OR, NV, ID, MT, WY, CO, UT, AZ, NM, and TX. (2) Better deal for ordering 2X, 4X, 6X rolls at a time!  (2) Always provide street address since shipping to P.O. Box address is SLOW.
QUALITY ASSURANCE:
Before, During, and After production. Get the print you want on the first try!
MOISTURE CONTROL –
Before production, our raw materials are dried for several hours to eliminate moisture prior to extrusion, preventing brittleness.
LASER PRECISION –
During production, the diameter of our filament is continuously monitored and controlled by laser measurement systems, minimizing the possibility of clogs.
VACUUM SEALED –
After production, our spools are each vacuum sealed with a silica gel packet to keep moisture locked out.
DEDICATION TO SERVICE –
All of our packages are personally inspected before being sent to distribution, ensuring our products are only sold after they meet our criteria.
Various Colors
Dimensional Accuracy
:
+/- 0.03mm.
Recommended PLA extrusion temperature:
210°C – 220°C (410°F – 428°F).
Keep the filament dry:
It is always a good practice to store the filament in an air-tight container with silica gel desiccant.
Drying PLA filament:
If needed, the filament may be dried in an oven with well controlled temperature at 70-77C (158F-170F) for 4 hours or so.   Higher temperature is good for drying but will deform the filament.  if you are a maker, check this link out to make an affordable device to constant supply Of dry filament:
https://www.youtube.com/watch?v=p1AQQ41gFDU
Strengthen your PLA prints
: Proper heat treatment (annealing) of a 3D PLA print can improve its strength and sturdiness. Symmetrical 3D print has a higher success rate compared with asymmetrical print. The recommended annealing temperature is 75-77C (167-170F). The time required will depend on the size, structure and fill rate of the print. You will have to experiment to decide. Check out this link for more info:
https://www.youtube.com/watch?v=CZX8eHC7fws
Trouble shooting
: Having some issues with your filaments? Check this link out for some good advice:
https://www.youtube.com/watch?v=WlmCc-vRNr0
All 1 kg spool filament of $12.99 or lower is sold as clearance and or wide-spec or AS-IS. No return or  replacement, please!
Wide-spec Product
are of transitional colors and/or of +/- 0.06 mm diameter accuracy. It
can be of any color or mix of colors. Its pictures show the variation of colors, not representing the product.  Wide spec is sold AS-IS, No return; No replacement.
A return
is allowed and full refund is
guaranteed
for none-used product. Used product may get a partial refund.  Damaged product  will not be accepted.